Filter
Top Products
OmniSwitch Troubleshooting Guide September 2005 page -13
debug ip packet
Enables/disables/configures the IP packet debug feature. This command is generally used only when
working with a field engineer to debug a problem on the switch.
debug ip packet [start] [timeout seconds] [stop] [direction {in | out | all}] [format {header | text | all}]
[output {console | file filename}] [board {cmm | ni [1-16] | all | none} [ether-type {arp | ip | hex
[hex_number] | all}] [ip-address ip_address] [ip-address ip_address] [ip-pair [ip1] [ip2]] [protocol {tcp
| udp | icmp | igmp | num [integer] | all}] [show-broadcast {on | off}] show-multicast {on | off}]
Syntax Definitions
start Starts an IP packet debug session.
timeout Sets the duration of the debug session, in seconds. To specify a dura-
tion for the debug session, enter timeout, then enter the session length.
seconds The debug session length, in seconds.
stop Stops IP packet debug session.
direction Specifies the type of the packets you want to debug. Specify in to debug
incoming packets; specify out to debug outgoing packets; specify all to
debug both incoming and outgoing packets.
format Specifies the area of the packet you want to debug. Specify header to
debug the packets header; specify hex to debug the packet text; specify
all to debug the entire packet.
output Specifies where you want the debug information to go. Specify console
to print the output to the screen; specify file to save the output to a log
file.
filename The filename for the output file.
board Specifies the slot (board) that you want to debug. Specify cmm to
debug CMM packets; specify ni, then enter the slot number of the NI to
debug a network interface card; specify all to debug packets for all
CMMs and NIs on the switch; specify none to clear the previous board
settings.
ether-type Specifies a specific Ethernet packet type to debug. Specify arp to debug
ARP packets; specify ip to debug IP packets; specify hex and enter an
ethernet packet type in hex format (e.g., 800) to debug a specific ether-
net packet type; specify all to debug all Ethernet packet types.
ip-address Specifies an IP address to debug. The debug output will only be for
packets received from this IP address. Enter ip-address, then enter the
IP address that you want to debug.
ip-pair Use this option to match packets exchanged between two network
addresses. Enter ip-pair, then enter each IP address.