Filter
Top Products
OmniSwitch Troubleshooting Guide September 2005 page -7
show tech-support layer3 ospf
Creates a log file of the output of several Open Shortest Path First routing (OSPF) Command Line Inter-
face (CLI) commands.
show tech-support layer3 ospf
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
• This command creates a file called tech_support_ospf.log in the /flash directory of the output
produced by the show ip ospf, show ip ospf area, show ip ospf interface, show ip ospf neighbor,
show ip ospf lsdb, show ip ospf host, show ip ospf border-routers, show ip ospf ext-lsdb, show ip
ospf redist, show ip ospf redist-filter, show ip ospf routes, show ip ospf virtual-link, and show ip
ospf debug CLI commands.
• If an existing file called tech_support_ospf.log already exists then it will be overwritten when this
command is executed.
• See the OmniSwitch CLI Reference Guide for more information on show commands.
• See Appendix B, “Debug Commands,” for more information on debug commands.
Examples
-> show tech-support layer3 ospf
.............
Release History
Release 5.1; command was introduced.
Related Commands
show tech-support Creates a log file of the output of system-wide CLI commands.
show tech-support layer2 Creates a log file of the output of several Layer 2 CLI commands.
show tech-support layer3 Creates a log file of the output of several Layer 3 CLI commands.