Filter
Top Products
OmniSwitch Troubleshooting Guide September 2005 page -3
show tech-support layer2
Creates a log file of the output of several Layer 2 Command Line Interface (CLI) commands.
show tech-support layer2
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
• This command creates a file called tech_support_layer2.log in the /flash directory of the output
produced by the show interfaces, show interfaces accounting, show interfaces collisions, show vlan
port, show vlan port mobile, show linkagg, show linkagg port, show spantree ports,
show mac-address-table count, show mac-address-table aging-time, show mac-address-table,
debug fabric stats, debug fabric fbus, debug fabric errors, debug fabric input, and debug fabric
stats CLI commands.
• If an existing file called tech_support_layer2.log already exists then it will be overwritten when this
command is executed.
• See the OmniSwitch CLI Reference Guide for more information on show commands.
• See Appendix B, “Debug Commands,” for more information on the debug fabric commands.
Examples
-> show tech-support layer2
................
Release History
Release 5.1; command was introduced.
Related Commands
show tech-support Creates a log file of the output of system-wide CLI commands.
show tech-support layer3 Creates a log file of the output of several Layer 3 CLI commands.