Filter
Top Products
page -52 OmniSwitch Troubleshooting Guide September 2005
debug interfaces backpressure
Displays if fabric back pressure is enabled or disabled on a Network Interface (NI) or an entire chassis.
debug interfaces [slot] backpressure
Syntax Definitions
slot The slot number to display the fabric back pressure state. The valid
range is 1–8 on an OmniSwitch 7700 and 1–16 on an OmniSwitch 7800,
and 1–16 on an OmniSwitch 8800.
Defaults
N/A
Platforms Supported
OmniSwitch 7700, 7800, 8800
Usage Guidelines
If the slot number is not specified then the switch back pressure state will be displayed for an entire chas-
sis.
Examples
-> debug interfaces backpressure
Slot Backpressure
------+--------------
1 disable
2 disable
3 enable
4 enable
5 disable
6 disable
7 disable
8 enable
-> debug interfaces 3 backpressure
Slot Backpressure
------+--------------
3 enable
Release History
Release 5.1; command was introduced.
output definitions
Slot The slot number of the NI.
Backpressure Displays if the switch fabric back pressure feature is enabled or dis-
abled on this NI. (The default is disabled.)