Filter
Top Products
1051
Chapter 68
LLDP and LLDP-MED Commands
The Link Layer Discovery Protocol commands are summarized in
Table 100 and described in detail within the chapter.
Table 100. LLDP and LLDP-MED Commands
Command Mode Description
“CLEAR LLDP STATISTICS” on
page 1054
Privileged Exec Clears the LLDP statistics (packet and
event counters) on the ports.
“CLEAR LLDP TABLE” on page 1055 Privileged Exec Clears the LLDP information the
switch has received from its
neighbors.
“LLDP HOLDTIME-MULTIPLIER” on
page 1056
Global
Configuration
Sets the holdtime multiplier value,
which the switch uses to calculate the
Time To Live (TTL) that it advertises
to the neighbors.
“LLDP LOCATION” on page 1057 Port Interface Adds LLDP-MED location information
to the ports on the switch.
“LLDP MANAGEMENT-ADDRESS”
on page 1059
Port Interface Replaces the default management IP
address TLV on the ports.
“LLDP MED-NOTIFICATIONS” on
page 1061
Port Interface Configures the switch to send LLDP-
MED topology change notifications
when devices are connected to, or
disconnected from, the specified
ports.
“LLDP MED-TLV-SELECT” on
page 1062
Port Interface Specifies the LLDP-MED TLVs the
ports are to transmit to their
neighbors.
“LLDP NON-STRICT-MED-TLV-
ORDER-CHECK” on page 1064
Global
Configuration
Configures the switch to either accept
or discard LLDP-MED advertisements
if the TLVs are not in standard order.
“LLDP NOTIFICATIONS” on
page 1065
Port Interface Configures ports to send LLDP SNMP
notifications (traps).