749
Chapter 50
GARP VLAN Registration Protocol
Commands
The GARP VLAN registration protocol commands are summarized in
Table 73 and described in detail within the chapter.
Table 73. GARP VLAN Registration Protocol Commands
Command Mode Description
“CONVERT DYNAMIC VLAN” on
page 751
VLAN
Configuration
Converts dynamic GVRP VLANs and
port assignments to static.
“GVRP APPLICANT STATE ACTIVE”
on page 752
Global
Configuration
Enables GIP on the switch.
“GVRP APPLICANT STATE
NORMAL” on page 753
Global
Configuration
Disables GIP.
“GVRP ENABLE” on page 754 Global
Configuration
Enables GVRP.
“GVRP REGISTRATION” on
page 755
Port Interface Set a port’s GVRP status.
“GVRP TIMER JOIN” on page 756 Global
Configuration
Sets the GARP Join Timer.
“GVRP TIMER LEAVE” on page 757 Global
Configuration
Sets the GARP Leave Timer.
“GVRP TIMER LEAVEALL” on
page 758
Global
Configuration
Sets the GARP Leave All timer.
“NO GVRP ENABLE” on page 759 Global
Configuration
Disables GVRP on the switch.
“NO GVRP TIMER JOIN” on page 760 Global
Configuration
Disables the GARP Join Timer.
“NO GVRP TIMER LEAVE” on
page 761
Global
Configuration
Disables the GARP Leave Timer.
“NO GVRP TIMER LEAVEALL” on
page 762
Global
Configuration
Disables the GARP Leave All timer.
“PURGE GVRP” on page 763 Global
Configuration
Disables GVRP on the switch and
returns the timers to their default
values.