Chapter 61: 802.1x Port-based Network Access Control Commands
894
AAA AUTHENTICATION DOT1X DEFAULT GROUP RADIUS
Syntax
aaa authentication dot1x default group radius
Parameters
None
Mode
Global Configuration mode
Description
Use this command to activate 802.1x port-based network access control
on the switch. The default setting for this feature is disabled.
Note
You should activate and configure the RADIUS client software on
the switch before activating port-based access control. For
instructions, refer to Chapter 88, “RADIUS and TACACS+ Clients”
on page 1361 or Chapter 89, “RADIUS and TACACS+ Client
Commands” on page 1377.
Confirmation Command
“SHOW DOT1X” on page 927
Example
This example activates 802.1x port-based network access control on the
switch:
awplus> enable
awplus# configure terminal
awplus(config)# aaa authentication dot1x default group
radius