Filter
Top Products
Chapter 10: Port Parameter Commands
164
“NO STORM-CONTROL” on
page 185
Port Interface Removes threshold limits for
broadcast, multicast, or unknown
unicast packets.
“POLARITY” on page 186 Port Interface Sets the MDI/MDI-X settings on
twisted pair ports.
“PURGE” on page 188 Port Interface Restores the default settings.
“RENEGOTIATE” on page 189 Port Interface Prompts ports that are using Auto-
Negotiation to renegotiate their
settings with the network devices.
“RESET” on page 190 Port Interface Performs software resets on the ports.
“SHOW FLOWCONTROL
INTERFACE” on page 191
Privileged Exec Displays the current settings for flow
control on the ports.
“SHOW INTERFACE” on page 193 Privileged Exec Displays port settings.
“SHOW INTERFACE BRIEF” on
page 197
Privileged Exec Displays administrative and link
statuses.
“SHOW INTERFACE STATUS” on
page 199
Privileged Exec Displays the speed and duplex mode
settings of the ports.
“SHOW PLATFORM TABLE PORT
COUNTERS” on page 201
Privileged Exec Displays packet statistics for the
individual ports.
“SHOW RUNNING-CONFIG
INTERFACE” on page 204
Privileged Exec Displays the settings of the specified
ports.
“SHOW STORM-CONTROL” on
page 205
Privileged Exec Displays threshold settings for
broadcast, multicast, and unknown
unicast packets.
“SHOW SYSTEM PLUGGABLE” on
page 207
Privileged Exec Displays information about the SFP
modules in the switch.
“SHOW SYSTEM PLUGGABLE
DETAIL” on page 208
Privileged Exec Displays information about the SFP
modules in the switch.
“SHUTDOWN” on page 209 Port Interface Disables ports to stop them from
forwarding network traffic.
“SNMP TRAP LINK-STATUS” on
page 210
Port Interface Activates link traps.
“SPEED” on page 211 Port Interface Manually sets port speed or activates
Auto-Negotiation.
Table 11. Port Parameter Commands (Continued)
Command Mode Description