Filter
Top Products
Chapter 19: Enhanced Stacking
354
3. Use the ESTACK RUN command in the Global Configuration mode to
activate enhanced stacking on the switch. It is not necessary to set the
switch to the member mode because that is the default setting.
4. To save the configuration, enter the WRITE command in the Privileged
Executive mode.
5. Connect port 1 on the new switch to a port on another network device
that is a member of the Network5A VLAN, such as the command
switch.
Now that the replacement member switch is connected to the command
switch through the common VLAN of the enhanced stack, you are ready to
upload the SalesE4.cfg configuration file to it from the command switch
with these steps:
1. Start a local or remote management session on the command switch
of the enhanced stack.
2. Transfer the SalesE4.cfg configuration file from the command switch
to the new member switch by performing these commands:
awplus(config-if)# end Return to the Privileged Exec
mode.
awplus# show vlan 12
Verify the new VLAN.
awplus# configure terminal
Enter the Global Configuration
mode.
awplus(config)# estack run
Activate enhanced stacking on the
new switch.
awplus(config)# exit
Return to the Privileged Exec
mode.
awplus# show estack
Confirm the stack mode of the
switch.
awplus# write
Save the configuration.
awplus> enable
Enter the Privileged Executive
mode from the User Executive
mode.
awplus# show estack remotelist
Display the SHOW ESTACK
REMOTELIST command to learn
the stack ID number of the
replacement member switch.