Filter
Top Products
Chapter 61: 802.1x Port-based Network Access Control Commands
892
“AUTH-MAC REAUTH-
RELEARNING” on page 906
Port Interface Forces ports that are using MAC
address authentication into the
unauthorized state.
“DOT1X CONTROL-DIRECTION” on
page 907
Port Interface Specifies whether authenticator ports
in the unauthorized state should
forward or discard egress broadcast
and multicast packets.
“DOT1X EAP” on page 909 Global
Configuration
Controls the action of the switch to
EAP packets when 802.1x
authentication is disabled on the
switch.
“DOT1X INITIALIZE INTERFACE” on
page 911
Port Interface Forces authenticator ports into the
unauthorized state.
“DOT1X MAX-REAUTH-REQ” on
page 912
Port Interface Specifies the maximum number of
times authenticator ports transmit
EAP Request packets to clients before
timing out authentication sessions.
“DOT1X PORT-CONTROL AUTO” on
page 913
Port Interface Sets ports to the authenticator role.
“DOT1X PORT-CONTROL FORCE-
AUTHORIZED” on page 914
Port Interface Configures ports to the 802.1x port-
based authenticator role in the forced-
authorized state.
“DOT1X PORT-CONTROL FORCE-
UNAUTHORIZED” on page 915
Port Interface Configures ports to the 802.1x port-
based authenticator role in the forced-
unauthorized state.
“DOT1X TIMEOUT TX-PERIOD” on
page 916
Port Interface Sets the amount of time the switch
waits for a reply from a client to an
EAP-request/identity frame.
“NO AAA AUTHENTICATION DOT1X
DEFAULT GROUP RADIUS” on
page 917
Global
Configuration
Disables 802.1x port-based network
access control on the switch.
“NO AUTH DYNAMIC-VLAN-
CREATION” on page 918
Port Interface Disables dynamic VLAN assignments
of authenticator ports.
“NO AUTH GUEST-VLAN” on
page 919
Port Interface Removes the VID of a guest VLAN
from an authenticator port.
“NO AUTH REAUTHENTICATION” on
page 920
Port Interface Removes reauthentication from
authenticator ports.
Table 87. 802.1x Port-based Network Access Control Commands (Continued)
Command Mode Description