AT-9000 Switch Command Line User’s Guide
403
Displaying IGMP Snooping
To display the settings of IGMP Snooping and its status, use the SHOW IP
IGMP SNOOPING command in the User Exec mode or Privileged Exec
mode:
awplus# show ip igmp snooping
Here is an example of the information the command displays:
Figure 87. SHOW IP IGMP SNOOPING
The information in the window is described in Table 42 on page 417.
IGMP Snooping Configuration:
IGMP Snooping Status ............... Enabled
Host Topology ...................... Single-Host/Port
Host/Router Timeout Interval ....... 255 seconds
Maximum IGMP Multicast Groups ...... 64
Router Port(s) ..................... Auto Detect
Router List:
VLAN ID Port/Trunk ID RouterIP Exp. Time
----------------------------------------------------
1 port1.0.31 10.0.0.254 110
Host List:
Number of IGMP Multicast Groups: 2
MulticastGroup VLAN ID Port/TrunkID HostIP IGMP Ver Exp.Time
------------------------------------------------------------
0100.5e7f.ffff 1 port1.0.1 192.169.20.50 v3 200
0100.5e7f.ffff 1 port1.0.30 172.16.20.222 v2 45
0100.5e64.3201 1 port1.0.15 10.10.5.01 v1 161