Filter
Top Products
x600 Series Layer 3 Gigabit Ethernet Switches Installation Guide
47
AT-LBM (Loop Back) Module
The x600-48Ts/XP switch is shipped from the factory with an AT-LBM
module installed in its expansion slot on the rear panel as shown in Figure
22.This module is factory installed for the non-stacking configuration. It
provides the capability for a full line rate, nonblocking switching
configuration when there are connections on the x600-48Ts/XP switch to
all 44 copper ports, two SFP ports, and two XFP ports. If you need to
configure the switch for stacking, you may install a VC Stacking Module
(AT-StackXG) in place of the AT-LBM Module.
Figure 22. AT-LBM Module installed in x600-48Ts/XP Expansion Slot
Note
1. The AT-LBM module is very similar to a blank panel in its outward
appearance except that it is marked with the “AT_LBM” model name
in the upper left-hand corner of the faceplate.
2. The x600-24Ts, x600-24Ts/XP, and x600-48Ts are all shipped
from the factory with a blank panel installed in the expansion slot.
RPS INPUT
100-240VAC~
AT-L BM
1309