Filter
Top Products
x600 Layer 3 Gigabit Ethernet Switch Installation Guide
73
Resetting the Switch
You may need to reset the switch after upgrading the firmware or after you
have made a configuration change that requires resetting the switch to
activate the change.
To reset the x600 switch, perform the following procedure:
1. Locate the RESET button which is on the right hand side of the
faceplate.
2. Press the RESET button with the tip of a pen or a similar
non-conducting object as shown in Figure 34.
Figure 34. Resetting the Switch
1321
x600-24Ts/XP
Layer 3 Gigabit Ethernet Switch
9 11 13 15 17 19 21R 23R
10 12 14 16 18 20 22R24R
FAU
L
T
RPS
MASTER
PWR
STATUS
21
22
23
24
SFP
L/A
BUSY
READY
FAU LT
SD
RESET
CONSOLE