Filter
Top Products
AMF Commands
AMF Software Reference Supplement for Allied Telesis x-Series Switches
C613-50031-01 REV B AlliedWare Plus
TM
Operating System - Software Version 5.4.3-1.4 and later 87
show atmf group
This command can be used to display the group membership within to a particular AMF
node. It can also be used with the working-set command to display group membership
within a working set.
Each node in the AMF is automatically added to the group that is appropriate to its
hardware architecture. e.g x510, x610. Nodes that are configured as masters are
automatically assigned to the master group.
You can create arbitrary groups of AMF members based on your own selection criteria.
You can then assign commands collectively to any of these groups.
Syntax show atmf group [user-defined|automatic]
Default
All groups are displayed
Mode User Exec - Privilege level 15
Example-1 To display group membership of node2, use the following command:
A typical output screen from this command is shown below:
This screen shows that node2 contains the groups, master and x510. Note that although
the node also contains the implicit groups, these do not appear in the show output.
Example-2 The following commands (entered on node2) will display all the automatic groups within
the working set containing node-1 and all nodes that have been pre-defined to contain
the sysadmin group:
First define the working-set
Parameter Description
group The amf group
user-defined User-defined-group information display
automatic Automatic group information display
node2#
show atmf group
ATMF goup information
master, x510
node2#
Node-1#
#atmf working-set node-1 group sysadmin