Filter
Top Products
AMF Commands
AMF Software Reference Supplement for Allied Telesis x-Series Switches
88 AlliedWare Plus
TM
Operating System - Software Version 5.4.3-1.4 and later C613-50031-01 REV B
A typical output screen from this command is shown below:
This confirms that the six nodes (node-1 to node-6) are now members of the working-set
and that these nodes reside within the ATMF_Network.
Note that to run this command, you must have previously entered the atmf working-set
command on page 75. This can be seen from the network level prompt, which in this case
is ATMF_NETWORK[6]#.
ATMF group information
master, poe, x8100
=========================================
node-1, node-2, node3, node-4, node-5, node-6:
==============================================
ATMF group information
sysadmin, x8100
ATMF_NETWORK[6]#
Figure 1-7: Sample output from the show atmf group command for a working set.
ATMF_NETWORK[6]#show atmf group
===========================
node3, node4, node5, node6:
===========================
ATMF group information
edge_switches, x510
Figure 1-8: Parameter definitions from the show atmf group command
Parameter Definition
ATMF group information Displays a list of nodes and the groups that they belong to,
for example:
■ master - Shows a common group name for Nodes
configured as AMF masters.
■ Hardware Arch - Shows a group for all Nodes sharing a
common Hardware architecture: e.g: x8100, x900, x610
etc.
■ User-defined - Arbitrary groups created by the user for
AMF nodes.