Filter
Top Products
7) Connect the mounting plate to the opening in the back
panel using the hardware provided. Partially insert one
screw into the bottom hole of the connector then slide
this screw over the notch at the bottom of the opening.
Make sure the writing (“OUT” and “IN”) is right side
up. Insert the top screw and tighten both screws.
* Notes The six-pin female connector at the end of the
mounting plate cable should be connected to the six-pin
connector on the SB. Make sure it is still firmly
connected.
Partially Insert bottom screw Connect the plate
(lettering should be upright)
* Important! You must connect the mounting plate to the
back panel of the computer for proper grounding. If you
do not, Sonic Blaster cannot function properly.
8) Now attach the loose end of the Ensoniq Input/Output
(E-I/O) cable to the seven-pin audio connector on the
IIGS motherboard. The cable is keyed so that it will fit
easily in one direction only.
Ch. 2 - Putting It In 7