Filter
Top Products
5-24
Chapter 5: Software support
6. Click OK after setting the values.
7. The following warning message appears when the operation is Split
data into RAID 0. Click Yes to continue or No to cancel.
8. A restart warning message appears after configuration is completed.
Click OK.
Create Stripe Raidset options
Source Displays the first selected disk.
Target All available disks except the first selected disk.
Create Only This operation destroys all data on the selected
disk and creates a clean stripe array without any
data.
Split data (Boot from IDE) This operation will split the data from the source disk
into all the selected disks. In this mode, the boot
disk may not be booted from the SiS 180 chip.
Split data (Boot from 180) This operation is similar to “Split data into RAID 0
operation, but the boot disk may boot from the
SiS 180 chip.
OK Starts the array configuration.
Cancel Aborts the array configuration.
<Disk Copy Remaining Sector> Displays the remaining splitting data
Refer to the SiS 180 Serial ATA User’s Manual in the support CD for
details on the SiSRAID utility.