Filter
Top Products
4-24
Chapter 4: BIOS setup
IRQ 3, 4, 5, 7, 9, 10, 11, 12, 14, 15 assigned to [PCI Device]
The IRQ Resources sub-menu is activated when the Resources
Controlled by parameter is set to [Manual]. Select [PCI Device] to
assign an IRQ address to a Plug and Play device. Setting to
[Reserved] reserves the IRQ address. Configuration options: [PCI
Devices] [Reserved]
PCI/VGA Snoop Palette [Disabled]
Some non-standard VGA cards, like graphics accelerators or MPEG video
cards, may not show colors properly. Setting this field to [Enabled] corrects
this problem. If you are using a standard VGA card, leave this field to the
default setting [Disabled]. Configuration options: [Disabled] [Enabled]
Assign IRQ for VGA [Enabled]
Setting this option to [Enabled] allows the BIOS to automatically assign an
IRQ address for the VGA controller.
Configuration options: [Disabled] [Enabled]
Assign IRQ for USB [Enabled]
Setting this option to [Enabled] allows the BIOS to automatically assign an
IRQ address for the USB controller.
Configuration options: [Disabled] [Enabled]
PCI Latency Timer (CLK) [64]
This option allows you to set the PCI latency timer. Select this option, then
press <Enter>. Enter a value (0 ~ 255) to set the timer.
IRQ Resources
IRQ-3 assigned to [PCI Device]
IRQ-4 assigned to [PCI Device]
IRQ-5 assigned to [PCI Device]
IRQ-7 assigned to [PCI Device]
IRQ-9 assigned to [PCI Device]
IRQ-10 assigned to [PCI Device]
IRQ-11 assigned to [PCI Device]
IRQ-12 assigned to [PCI Device]
IRQ-14 assigned to [PCI Device]
IRQ-15 assigned to [PCI Device]
IRQ Resources
F1 : Help
↑↓
: Select Item -/+ : Change Value F5 : Setup Defaults
ESC : Exit
→←
: Select Menu Enter : Select Sub-menu F10 : Save and Exit
Select Menu
Item Specific Help
Legacy ISA for devices
compliant with the
original PC AT bus
specification, PCI/ISA
PnP for devices
compliant with the Plug
and Play standard
whether designed for PCI
or ISA bus architecture.