Filter
Top Products
6
Chapter 2
Setup
Getting Started
To begin using the Phantom-S with your PS/Xbox, requires two steps:
1. Connecting Hardware
2. Configuring Mouse Settings
Connecting Hardware
To connect the UC410 to a game console use the steps below. To connect the
UC410 to a computer use steps 7-9 on the next page. To connect to a computer
and console simultaneously see Computer / Laptop + Console Setup, page 9.
Game Console
NOTE: If a wireless controller is used to power on the PS/Xbox, the game
console will not recognize the UC410 as a controller. All wireless controllers
need to be turned off.
Power off the game console & wireless controllers then use the diagram on
page 8 to do the following:
1. Connect a game controller to the Gamepad Port.
2. Connect a keyboard to the Keyboard Port.
3. Connect a mouse to the Mouse Port.
4. Connect the UC410 Game Port to the PS/Xbox USB port #1 with a mini/
micro USB cable.
5. Power on the PS/Xbox from the console*.
Do not use a wireless controller to power on the PS/Xbox console.
6. The UC410 is ready for use.
Note: The PS4 controller connected to the UC410 should have an Orange
light bar when the console is powered on. If the light bar is blue – power
off the game console & controllers, then repeat the steps above.