Filter
Top Products
Chapter 3: Local Port Operation 27
4. Type the first few characters of a target device name or port number to scan. The first matching
target device will appear in the line.
-or-
Press the following keyboard commands in the Name, Port or Time column to move through
the list of target devices available to scan.
a. Press Alt+Down Arrow to move the cursor down through the list of target devices.
b. Press Alt+Up Arrow to move the cursor up through the list of target devices.
c. Press Alt+Home to move the cursor to the first target device in the list.
d. Press Alt+End to move the cursor to the last target device in the list.
5. In the Time column, type the number of seconds (from 3-255) of desired time before the scan
moves to the next target device in the sequence.
6. Move the cursor to the next line or press Down Arrow and repeat steps 2-5 for each of the
remaining target devices to be included in the scan pattern.
7. Click OK to save your settings.
To remove a target device from the Scan list:
1. In the Scan dialog box, click the target device to be removed.
2. Press Delete.
-or-
Press Shift+Delete to remove the selected target device and all entries below it.
3. Click OK to save your settings.
To start the Scan mode:
1. If the OSCAR interface is not open, press Print Screen to open the Main dialog box.
2. Click Commands to open the Commands dialog box as shown in Figure 3.12.
Figure 3.12: OSCAR Interface Commands Dialog Box