Filter
Top Products
61
CHAPTER
6
Terminal Operations
The Console Menu
Each AutoView 3100/3200 switch may be configured at the appliance level through the Console
menu interface accessed through the SETUP port on the back of the switch. All terminal commands
are accessed through a terminal or PC running terminal emulation software.
Network Configuration
To configure network settings using the Console menu:
1. When you power up your AutoView 3100/3200 switch, the switch initializes for
approximately one minute. After it completes initialization, press any key on the terminal or on
the PC running the terminal emulation software to access the Console menu interface shown in
Figure 6.1 on page 62.
NOTE: The terminal may be connected at any time, even when the switch is already powered.