Filter
Top Products
3. Physical installation
How to install the batteries in the remote control ?
1. Push the battery cover tab with the fi ngernail a little backwards (1) and pull, at the same time, the cover upwards (2).
1
2
Image 3-2
2. Insert the two AA size batteries, making sure the polarities match the + and - marks inside the battery compartment.
+
+
-
-
Image 3-3
3. Insert (1) the lower tab of the battery cover in the gap at the bottom of the remote control, and press (2) the cover until it clicks
in place.
+
+
-
-
1
2
Image 3-4
CAUTION: Replace with the correct battery type. Use two AA size batteries. There is a risk of explosion if the
battery is replaced with an incorrect type.
CAUTION: Replace the battery as explained above. There is a risk of explosion if the battery is incorrectly
installed.
3.1.2 RCU rugged case installation
How to install the rugged case of the remote control ?
1. Slide the bottom of the RCU into
the rugged case and then pull the top of the rugged case over the top of the RCU as illustrated.
24
R5905032 HDX SERIES 02/03/2015