Barco HDX W12 Projector User Manual


 
3. Physical installation
3. Turn in the rigging clamps into the rigging points using a 17 mm open ended spanner and secure the rigging clamps by turning
the safety nut on the rigging clamp against the rigging point using a 17 mm open ended spanner.
Image 3-52
Mount rigging clamps
Warning: Alwa ys use four (4) rigging points, equally spread, to suspend the projector.
4. Place all four rigging clamps in open position.
5. Place the projector (upside down) under the truss installation and lower the truss until the support bars of the truss are nearby
the rigging clamps mounted on the projector.
Image 3-53
Mount to truss
6. Lift up the projector and hook the four rigging clamps over the support bars of the truss.
R5905032 HDX SERIES 02/03/2015
43