Filter
Top Products
R5975059A BARCOVISION 708 200498
APPENDIX B : ORBITING
APPENDIX B : ORBITING
R5975059A BARCOVISION 708 200498
APPENDIX B : ORBITING
APPENDIX B : ORBITING
B-3
B-3
MASTER Orbiting)
Highlight 'SPEED : SLOW' with
the control disc and press ENTER
to set the ORBITING SPEED to
Fast.
Highlight 'SPEED : FAST' with the
control disc and press ENTER to
set the ORBITING SPEED to Slow
ENTER continues to Set up Orbiting.
EXIT returns to the Path Selection menu.
ADJUST returns to the Operational mode.
Orbiting alignment
Preparation :
Before proceeding to the alignment of the Orbiting default settings, be sure that the
Horizontal Phase and the Raster shift are correctly aligned with the Orbiting mode
set to OFF.
This alignment must be performed in case of a multiple projector installation with
Master and Slave projectors in order to ensure a correct operation of the Orbiting
for all projectors.
Adjustment procedure stand alone projector :
Highlight 'ADJUST DEVIATION'
with the control disc and press
ENTER.
<EXIT> to return.
SELECT WITH é OR ê
THEN <ENTER>
DEVIATION ADJUST :
VERTICAL WITH é OR ê
HORIZONTAL WITH ç OR è
MASTER ORBITING
CHANGE TO SLAVE
MODE: ON
SPEED: FAST
ADJUST DEVIATION
<EXIT> to return.
SELECT WITH é OR ê
THEN <ENTER>
DEVIATION ADJUST :
VERTICAL WITH é OR ê
HORIZONTAL WITH ç OR è
MASTER ORBITING
CHANGE TO SLAVE
MODE: ON
SPEED: FAST
ADJUST DEVIATION
MASTER Orbiting)
Highlight 'SPEED : SLOW' with
the control disc and press ENTER
to set the ORBITING SPEED to
Fast.
Highlight 'SPEED : FAST' with the
control disc and press ENTER to
set the ORBITING SPEED to Slow
ENTER continues to Set up Orbiting.
EXIT returns to the Path Selection menu.
ADJUST returns to the Operational mode.
Orbiting alignment
Preparation :
Before proceeding to the alignment of the Orbiting default settings, be sure that the
Horizontal Phase and the Raster shift are correctly aligned with the Orbiting mode
set to OFF.
This alignment must be performed in case of a multiple projector installation with
Master and Slave projectors in order to ensure a correct operation of the Orbiting
for all projectors.
Adjustment procedure stand alone projector :
Highlight 'ADJUST DEVIATION'
with the control disc and press
ENTER.
<EXIT> to return.
SELECT WITH é OR ê
THEN <ENTER>
DEVIATION ADJUST :
VERTICAL WITH é OR ê
HORIZONTAL WITH ç OR è
MASTER ORBITING
CHANGE TO SLAVE
MODE: ON
SPEED: FAST
ADJUST DEVIATION
<EXIT> to return.
SELECT WITH é OR ê
THEN <ENTER>
DEVIATION ADJUST :
VERTICAL WITH é OR ê
HORIZONTAL WITH ç OR è
MASTER ORBITING
CHANGE TO SLAVE
MODE: ON
SPEED: FAST
ADJUST DEVIATION