Filter
Top Products
R5975059A BARCOVISION 708 200498
POWER CONNECTION
POWER CONNECTION
POWER CONNECTION
POWER CONNECTION
R5975059A BARCOVISION 708 200498
3-2
3-2
Power (mains) cord connection
Use the supplied power cord to connect your projector to the wall outlet. Plug
the female power connector into the male connector at the front of the projector.
Switching on/off
The projector is switched ON and OFF using the power (mains) switch ON/OFF.
Pressed : ON
Not pressed : OFF
The projector can start now in the 'operational mode' (image displayed) or in the
'stand by mode', depending on the position of the 'power up' dip switch on the
controller unit. This DIP switch is set during installation by a qualified technician.
If you want to change this start up mode, call a qualified technician.
Stand by indication lamp :
no light up : projector in operational mode
red : projector is in stand by.
-9V
HOLD DOWN HD
COINC
SF
HOLD DOWN EHT
Stand-by
-CONV
-17V
+17V
+HTHD
+CONV
+9V
+210V
+30V
LEDs on the front plate of the projector
OFF ON
See installation instructions before
connecting to the supply
V NOM 120/230 Volt
I MAX 5/2.5 AMP
FREQ 60/50 Hz
OFF
ON
See ins tall ation i nstruc tions bef ore
connect ing to th e suppl y
V NOM 120 /230 Volt
I MAX 5/2.5 AMP
FREQ 60/ 50 Hz
Power (mains) cord connection
Use the supplied power cord to connect your projector to the wall outlet. Plug
the female power connector into the male connector at the front of the projector.
Switching on/off
The projector is switched ON and OFF using the power (mains) switch ON/OFF.
Pressed : ON
Not pressed : OFF
The projector can start now in the 'operational mode' (image displayed) or in the
'stand by mode', depending on the position of the 'power up' dip switch on the
controller unit. This DIP switch is set during installation by a qualified technician.
If you want to change this start up mode, call a qualified technician.
Stand by indication lamp :
no light up : projector in operational mode
red : projector is in stand by.
-9V
HOLD DOWN HD
COINC
SF
HOLD DOWN EHT
Stand-by
-CONV
-17V
+17V
+HTHD
+CONV
+9V
+210V
+30V
LEDs on the front plate of the projector
OFF ON
See installation instructions before
connecting to the supply
V NOM 120/230 Volt
I MAX 5/2.5 AMP
FREQ 60/50 Hz
OFF
ON
See ins tall ation i nstruct ions bef ore
connect ing to th e suppl y
V NOM 120 /230 Volt
I MAX 5/2.5 AMP
FREQ 60/ 50 Hz