Filter
Top Products
Chapter 9 Trouble Shooting
Daylight Display Systems 129 BARCO DLite Software
Source and Image Control
THE ACTIVE VIDEO IS JOINED BY A VERTICAL BAR AT THE BOTTOM AND
A HORIZONTAL BAR AT THE RIGHT. THIS MEANS THE BLANKING IS
COMING THROUGH.
Check the setting Insert Blanking in the Advanced Settings window. This setting should be turned Off
THE ACTIVE VIDEO OR THE ACTIVE BORDERS ARE SCRAMBLED. MAKE
SURE THAT THE LED WALL MASK IS BETWEEN THE WHITE ACTIVE VIDEO
BORDERS!
Check the H Start (> 52) & V Start (> 36)
THE VIDEO SEEMS NOISY, SPECIALLY IN THE DARKER COLORS
Check the Video Equalizing settings in the Daylight Display Digitizer Imaging window
THE VIDEO IS FROZEN
Check the setting Full Frame Freeze in the Advanced Settings window
Check the settings on the selected video source
THE VIDEO COLORS ARE PALE / GRAY
Check the Saturation setting in the Daylight Display Digitizer Imaging window
THE VIDEO ISNT SHOWN BRIGHT EVEN WHEN THE LIGHT OUTPUT IS SET
ON A HIGH SETTING
Check the Brightness setting in the Daylight Display Digitizer Imaging window
THE DATA IS DISPLAYED IN A PARALLELOGRAM SHAPE
Lower the data size in the Windowing Toolbox provided with the Video Scaling window
THE DATA DOESNT SHOW WHILE THE SETTING DATA ON VIDEO IS
SELECTED
Adjust the Data Panning and Size in the Windowing Toolbox provided with the Video Scaling window
THE DIGITIZER DOESNT COME OUT OF STAND-BY MODE
Check whether the fiberlink if included is fully operational