Barco R9828832 Projector Accessories User Manual


 
Daylight Display Systems 133 BARCO DLite Digitizer
Chapter 10
Digitizer
Operation
POWER REQUIREMENTS
The Digitizer D
3
10 is equipped with a built-in Power Supply
Autoranging from 100 to 240 V, 80W, 1.2-0.7A, 50 - 60 Hz.
FEDERAL COMMUNICATION COMMISSION
(FCC STATEMENT)
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
SERVICE SAFETY PRECAUTIONS
WARNING
TO PREVENT FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE THIS DEVICE TO RAIN OR MOISTURE
VENTILATION
THE DIGITIZER WILL REQUIRE THAT AIR FLOWS FREELY IN BOTH THE BOTTOM AND TOP VENT HOLES. BLOCKING THESE
HOLES WILL GREATLY REDUCE THE RELIABILITY OF THE UNIT AND LEAD TO THE POSSIBILITY OF OVERHEATING.
THE MAXIMUM RECOMMENDED AMBIENT TEMPERATURE FOR THIS EQUIPMENT IS 40ºC
The exclamation point within a triangle is intended to tell the
user that important operating and/or servicing instructions
are included in the technical documentation for this equipment.
The lightning flash with an arrowhead within a triangle is
intended to tell the user that parts inside this product may
cause a risk of electrical shock to persons.