Filter
Top Products
724-746-5500 | blackbox.com
Page 112
LGB5028A User‘s Manual
724-746-5500 | blackbox.com
Chapter 6: Configuration
Parameter Description
MAC Table Columns
Type: Indicates whether the entry is a static or a dynamic entry.
VLAN: The VLAN ID of the entry.
MAC Address: The MAC address of the entry.
Port Members: The ports that are members of the entry.
Auto-refresh: Check the box next to auto-refresh and the device will refresh the information automatically.
Upper right icon (Refresh, Clear, <<, >>): Click “Refresh” to refresh the MAC address entries by manual, or press “Clear” to
clean up the MAC table. Press “<<” or “>>” to go to the next/previous page of the table.
NOTE: 00-40-C7-73-01-29: your switch MAC address (for IPv4)
33-33-00-00-00-01: Destination MAC (for IPv6 Router Advertisement) (reference IPv6 RA.JPG)
33-33-00-00-00-02: Destination MAC (for IPv6 Router Solicitation) (reference IPv6 RS.JPG)
33-33-FF-73-01-29: Destination MAC (for IPv6 Neighbor Solicitation) (reference IPv6 DAD.JPG)
33-33-FF-A8-01-01: your switch MAC address (for IPv6 global IP)
FF-FF-FF-FF-FF-FF: for Broadcast.
6.10 VLAN
Assign a specific VLAN for management. The management VLAN is used to establish an IP connection to the switch from a
workstation connected to a port in the VLAN. This connection supports a VSM, SNMP, and Telnet session. By default, the active
management VLAN is VLAN 1, but you can designate any VLAN as the management VLAN using the management VLAN
swindow. Only one management VLAN can be active at a time.
When you specify a new management VLAN, your HTTP connection to the old management VLAN is lost. For this reason, you
should have a connection between your management station and a port in the new management VLAN or connect to the new
management VLAN through a multi-VLAN route.
6.10.1 VLAN Membership
You can monitor and modify the VLAN membership configuration for the selected switch unit here. Up to 4096 VLANs are
supported. This page enables you to add and delete VLANs as well as add and delete port members of each VLAN.
Web Interface
To configure VLAN membership in the Web interface:
1. Click “VLAN Membership Configuration.”
2. Specify Management VLAN ID. (0–4094)
3. Click “Save.”