Filter
Top Products
724-746-5500 | blackbox.com
724-746-5500 | blackbox.com
Page 141
LGB5028A User‘s Manual
Chapter 6: Configuration
Queue Scheduler Percent: If you select the scheduler mode with weighted, then the screen will change as shown in Figure
6-69. Show the weight in percent for this queue. This parameter is only shown if “Scheduler Mode” is set to “Weighted.”
Port Shaper Enable: Control whether the port shaper is enabled for this switch port.
Port Shaper Rate: Control the rate for the port shaper. The default value is 500. This value is restricted to 1–1000000 when the
unit is “kbps,” and it is restricted to 1–10000 when the unit is “Mbps.”
Port Shaper Unit: Control the unit of measure for the port shaper rate as “kbps” or “Mbps.” The default value is “kbps.”
Buttons:
Save: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved values.
6.14.4 Port Shaping
This section provides an overview of QoS egress port shaping for all switch ports. The user could get all detail information of the
ports belonging to the currently selected unit, as reflected by the page header.
Web Interface
To display the QoS port shapers in the Web interface:
1. Click “Configuration,” “QoS,” “Port Shapers.”
2. Display the QoS egress port shapers.