Filter
Top Products
724-746-5500 | blackbox.com
Page 54
LGB5028A User‘s Manual
724-746-5500 | blackbox.com
Chapter 6: Configuration
MAC Parameters:
SMAC Filter: (Only display when the frame type is Ethernet Type or ARP.) Specify the source MAC filter for this ACE.
Any: No SMAC filter is specified. (SMAC filter status is “don't-care.”)
Specific: If you want to filter a specific source MAC address with this ACE, choose this value. A field for entering an SMAC value
appears.
SMAC Value: When “Specific” is selected for the SMAC filter, you can enter a specific source MAC address. The legal format is
"xx-xx-xx-xx-xx-xx" or "xx.xx.xx.xx.xx.xx" or "xxxxxxxxxxxx" (x is a hexadecimal digit). A frame that hits this ACE matches this
SMAC value.
DMAC Filter: Specify the destination MAC filter for this ACE.
Any: No DMAC filter is specified. (DMAC filter status is “don't-care”.)
MC: Frame must be multicast.
BC: Frame must be broadcast.
UC: Frame must be unicast.
Specific: If you want to filter a specific destination MAC address with this ACE, choose this value. A field for entering a DMAC
value appears.
DMAC Value: When "Specific" is selected for the DMAC filter, you can enter a specific destination MAC address. The legal
format is "xx-xx-xx-xx-xx-xx" or "xx.xx.xx.xx.xx.xx" or "xxxxxxxxxxxx" (x is a hexadecimal digit). A frame that hits this ACE
matches this DMAC value.
VLAN Parameters: Specify the VLAN parameters.
VLAN ID Filter: Select an option from the drop-down menu.
Tag Priority: Select an option from the drop-down menu.
Buttons:
Save: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved values.
Auto-refresh: Check this box to refresh the information automatically.
Upper right icon (Refresh, Clear, Remove All): Click on this button to refresh the ACL configuration or manually clear the ACLs.
Choose “Remove All” all to remove all ACL configurations on the table.
6.2.4 ACL Status
The section shows the ACL status by different ACL users. Each row describes the ACE that is defined. A conflict occurs if a specific
ACE is not applied to the hardware because of hardware limitations. The maximum number of ACEs is 256 on each switch.
Web Interface
To display the ACL status in the Web interface:
1. Click “Configuration,” “ACL,” then “ACL status.”
2. To auto-refresh the information, click on the “Auto-refresh” button.
3. Click ““Refresh” to refresh the ACL Status.