Filter
Top Products
724-746-5500 | blackbox.com
724-746-5500 | blackbox.com
Page 83
Chapter 4: E2 Controller
4.5.5.8 BMS Communications
Figure 4-60. BMS Communcations screens.
The Service>BMS Comm menu is used to set up parameters to allow a BMS (BAS) to interface with the controller. See Section
4.7.2 for a description of this screen and instructions for setting up BMS communication.
4.5.5.9 Save Configuration
Figure 4-61. Save Configuration screen.
The default setpoints may be restored and passwords may be changed from the Service>Save Cfg menu.
Figure 4-62. Customer Save screen.
The first Service>Save Cfg menu screen allows you to save any adjustments made in service level menu screens as the new
“Customer” parameters or, restore the controller to the previously saved “Customer” parameters. The user may also restore the
controller to the original factory default parameter values shown in Table 4-10.
Use the Enter key to move the flashing cursor to the field you wish to confirm and press the Up or Down arrow key. The word
“No” will momentarily change to “Yes,” indicating the command has been accepted. Then press the Enter key sequentially until
the flashing cursor returns to the top left corner of the screen.
The table that follows are the factory default parameters.