Filter
Top Products
724-746-5500 | blackbox.com
Page 90
724-746-5500 | blackbox.com
Chapter 4: E2 Controller
Figure 4-73. Firmware version.
To exit the Network Status loop, press Enter .
The next step is to access the Factory>Group screens used to configure the workgroup parameters (Section 4.6.2.6).
4.6.2.6 Configure Workgroups
The Factory>Group menu screens only appear when multiple A/C units are grouped. These menu screens allow you to define
grouping parameters (duty, rotation, offsets, etc.) for the A/C units in the workgroup. These screens should be accessed after
setting up the workgroups (Section 4.6.2). The Factory>Group menu screens may be accessed from the main screen by pressing
the Prg key and scrolling through the menu selections until the word Factory appears in the center of the screen.
Figure 4-74. Factory>Group screen.
Press the Enter key twice and you’ll be prompted to enter the password for the Factory level (contact Black Box Technical
Support for the password).
Once the factory-level password is entered, press Enter to call up the menu screens. From here, you may press the up-arrow
or down-arrow keys to scroll through the Factory menu selections.
Figure 4-75. Group screen.
When the word GROUP appears in the center of the screen, press the Enter key to access the Factory>Group menu screens.
From here, you may use the up-arrow or down-arrow keys to scroll through the Factory>Group menu selections.