Filter
Top Products
49
CHAPTER 3: Getting Started: Fiber Optic Networks
2. To change the number of Splices, use the down-arrow to highlight the field
and press ENTER. Use the up-arrow or down-arrow key to adjust the number
of splices in your link. To determine the total number of splices, simply count
all of the splices on one fiber. OMNIScanner will assume that both fibers of a
duplex link have the same amount of splices.
3. After editing the fields, press to run the Autotest.
OMNIScanner starts the Autotest after the number of connections and splices
has been entered.
NOTE
If you are running a Fiber Test Options for further information.)
4. Swap the Launch Cable’s connectors as indicated in the graphic. Do not
disconnect the Launch Cables from the OMNIFiber adapters!
5. Press to complete the Autotest.