Filter
Top Products
Network Scanning
95
4
f Press Mono Start or Color Start.
The machine starts the scanning process.
Note
• Scan type depends on the settings on the Device Button tab, Mono Start or Color Start do not change
the settings.
• If you want the scanned data in color, choose color in scan type on the Device Button tab of the
ControlCenter3 configuration. If you want the scanned data in black and white, choose black and white in
scan type on the Device Button tab of the ControlCenter3 configuration. (See SCAN on page 65.)
• If you would like to change the file name of scanned documents, enter the file name in File Name section
on the Device Button tab of the ControlCenter3 configuration. To change the machine’s Scan key
settings, right-click the each Control Center buttons, click ControlCenter Configuration and click the
Device Button tab.
Scan to FTP 4
When you choose Scan to FTP, you can scan a black and white or color document directly to an FTP server
on your local network or on the internet.
The details required to use Scan to FTP can be entered manually at the control panel or by using Web Based
Management to pre-configure and store the details in an FTP Profile.
For information on how to manually enter the Scan to FTP details, see Scan to FTP Manual
Method on page 99. To use Web Based Management, type http://xxx.xxx.xxx.xxx (where xxx.xxx.xxx.xxx
is the IP address of your machine) into your browser, and then you can configure or change the settings in
the Administrator Settings. You can configure up to ten FTP server profiles.