Filter
Top Products
Chapter 6
56
Remote Fax commands 6
Follow the commands below to access features when you are away from the machine. When you
call the machine and enter your remote access code (3 digits followed by l), the system will give
two short beeps and you must enter a remote command.
Remote commands Operation details
91 Playing Voice messages After one long beep, the machine plays the ICM.
1 Repeat or Skip Backward Press 1 while listening to an ICM to repeat it. If you press 1
before a message, you will hear the previous message.
2 Skip Forward While playing the ICM, you can skip to the next message.
9 STOP Playing Stop Playing the ICM.
93 Erase all ICM If you hear one long beep, the erase is accepted. If you hear
three short beeps, you cannot erase because all voice
messages have not been played, or there are no voice
messages to erase.
*This code erases all recorded messages, not one at a time.
94 Play and Record OGM in Memory
1 Play 1 TAD Message The machine plays the selected OGM. You can stop playing
OGMs by pressing 9.
2 F/T Message
2 Record 1 TAD Message After one long beep, you can record the selected OGM. You
will hear the message played once. You can stop recording
the message by pressing 9.
2 F/T Message
95 Change the Fax Forwarding or Fax
Storage settings
1 OFF You can choose Off after you have retrieved or erased all
your messages.
2 Fax Forwarding One long beep means the change is accepted. If you hear
three short beeps, you cannot change because something
has not been set up (for example, a Fax Forwarding number
has not been registered). You can register your Fax
Forwarding number by entering 4. (See Changing your Fax
Forwarding number on page 57.) Once you have registered
the number, Fax Forwarding will work.
4 Fax Forwarding number
6 Fax Storage
96 Retrieve a fax
2 Retrieve all faxes Enter the number of a remote fax machine to receive stored
fax messages. (See Retrieving fax messages on page 57.)
3 Erase faxes from the memory If you hear one long beep, fax messages have been erased
from the memory.
97 Check the receiving status
1 Fax You can check whether your machine has received any
faxes or voice messages. If yes, you will hear one long
beep. If no, you will hear three short beeps.
2 Voice