Filter
Top Products
4 - 15 CONTROL PANEL
■ NetWare (default: Enabled)
Set NetWare to 'Enabled' to print in a NetWare system or to 'Disabled' if you do not want to use
this feature.
■ AppleTalk (default: Enabled)
Set AppleTalk to 'Enabled' to print in an AppleTalk system or to 'Disabled' if you do not want to
use this feature.
IP Filter
Use IP Filter to block the reception of data from certain locations.
To block a particular IP address, specify the IP address in 'FilterX Address' (X is a number between 1
and 5) and the subnet mask in 'FilterX Mask' as numbers between 0 and 255. For the set address, select
'OFF' (default), 'Reject', or 'Accept' from 'FilterX Mode'.
You can filter up to 5 addresses. Filter1 takes priority over the other filters. Therefore, when setting filters
for a number of addresses, assign the addresses in ascending ranges from Filter1 to Filter5.
■ You can also set IP filter settings by connecting to the printer using a web browser. For a detailed
examples of these settings, see the Network User's Guide on the CD-ROM we provided.
■ For more information about Web Based Management, see Confirming Printer Status from Your
Computer on page 7-21.
Init NVM
This resets the non-volatile memory of the printer’s network card (also known as a print server).
You cannot change this setting while the printer is processing print data.
■ YES
Resets the network card's NV memory. Resetting the NV memory restores the items of the '5
Network' menu to their defaults.
You must restart the printer for this setting to take effect. After programming settings, be sure to restart
the printer.
■ NO
Does not reset the NV memory and returns to the menu.
Adobe Protocol
To set the Adobe Protocol choose one of the following:
■ Auto (default)
■ Standard
■ BCP
■ TBCP
■ RAW