Filter
Top Products
102
CHAPTER TWELVE
Remote Control Commands
Follow the commands below to access features remotely. When you call the
MFC and enter your Remote Access Code (159 ), the system will signal
you with two short beeps to enter a remote control command.
Remote Control Commands
91 Playing voice messages
1 (Skip back)
2 (Skip next)
9 Stop Playing
92 Record Memo
93 Erase all ICM & Memo
94 Play and Record OGM
in memory
1 Play 1 MSG CTR OGM
2 F/T OGM
2 Record 1 MSG CTR OGM
2 F/T OGM
95 Changing Fax Forwarding/
Paging setting
1 OFF
2 Fax Forwarding
3 Paging
4 FAX FWD NO.
96 Retrieve Fax
1 Memory Status List
2 Retrieve all FAX
3 Erase FAX in the
memory
Details Operation
After one long beep, the MFC plays ICMs and Memos.
Press 1 while listening to an ICM or Memo message to play
it again. If you press 1 before a message, you will reply the
previous message.
While playing an ICM or Memo, you can skip to next
message.
Stop playing the ICM and Memo.
After one long beep, you can record a memo. You can stop
recording by pressing 9.
If you hear one long beep, the erase is accepted. If you hear
three short beeps, you cannot erase because all voice messages
have not been played, or there is no voice message to erase.
*This code erases all recorded messages, not one at a time.
The MFC plays the selected OGM. You can stop playing
OGMs by pressing 9.
After one long beep, you can record the selected OGM. Your
recorded message will be played when you finish speaking.
You can stop recording the message by pressing 9.
If you hear one long beep, the change is accepted. If you hear
three short beeps, you cannot change it because the conditions
have not been met (Example: registering paging number). You
can register your fax forwarding number by using 4. FAX
FWD NO (see page 104). Once you have registered the
number, the MFC will automatically change to
“FAXFWD:ON” mode. Then retrieve a Memory Status List by
entering 961 (see page 103) to make sure that the Fax
Forwarding number you registered is correct in the List.
Enter the number of a remote fax machine to receive a report
or stored fax messages. (See page 103.)
If you hear one long beep, you can erase the fax message
from the memory.
97 Check the receiving status
1 FAX
2 VOICE
98 Change Answer Mode
1 MSG CTR
2 FAX/TEL
3 FAX
90 Exit
You can check whether your MFC has received any FAX or
VOICE messages. If yes, you will hear one long beep. If no,
you will hear three short beeps.
If you hear one long beep, you can change the answer mode.
If you hear three short beeps, you cannot change it (For
example: When there is no MSG CTR OGM and you tried to
change to MSG CTR mode.)
After a long beep, you can exit remote control.