Cabletron Systems 04-0053-01 Switch User Manual


 
SmartSwitch ATM User Guide 2-5
IP Over ATM and LANE Creating an Emulated LAN
Note When you create a client, it automatically finds the LECS address using ILMI.
Note The command add laneclient always prompts you with a subnet mask that is
appropriate for the IP address. However, if necessary, you can change the subnet
mask to correspond to the strategy employed within your networks.
As the local client joins the ELAN, the following messages are sent to the Event Log (see Chapter 9,
"Troubleshooting." Section 9.5):
NOTICE - 'ZLESSRV' LES Join 39:00:00:00:00:00:00:00:00:00:14:41:80:00:20:D4:
14:41:82:00
NOTICE - 'ZLESSRV' BUS Connect 39:00:00:00:00:00:00:00:00:00:14:41:80:00:20:D4:
14:41:82:00
Caution Never create an ELAN (or ELAN client) with the same subnet as the ATM
SmartSwitch’s Ethernet port.
4. Enter the show client command verify that the client is operational.
SmartSwitch # show client 1
LANE Client 1
============================================================================
Client State : Operational
Client Address : 39:00:00:00:00:00:00:00:00:00:14:41:80:00:20:D4:14:41:81:00
LAN Name : Marketing
LECS Addr Source : ILMI
LECS Address : 39:00:00:00:00:00:00:00:00:00:14:41:80:00:20:D4:14:41:80:01
LES Address : 39:00:00:00:00:00:00:00:00:00:14:41:80:00:20:D4:14:41:82:02
LAN Type : 802.3
MTU : 1516
IP Address : 90.1.1.1
IP NetMask : 255.255.255.0
SmartSwitch #
Note While creating an ELAN client for the switch is not absolutely necessary, it does
provide management connectivity with the switch over its ATM ports (instead of
the Ethernet port). See Chapter 4, "Routing." Section 4.5 for information about
how to reach switches not directly connected to the Ethernet network.
5. Physically connect your end nodes and edge devices to the ATM SmartSwitch ports.
6. Configure the ATM interface or adapter for all end nodes and edge devices. Typically, configuration
consists of specifying LAN Emulation as the connection type, assigning the device an IP address that
corresponds to the subnet of the switch’s client, and indicating that you want the device to either