Cabletron Systems 6H122-16 Switch User Manual


 
Chapter 1:
Introduction
1-4 6H122-16 User’s Guide
1.3.3 Distributed Chassis Management
From a management perspective, the 6C105 SmartSwitch 6000 chassis
can be viewed as a single entity with a single IP address. Its management
functions are distributed to all modules. This means a single module in
the chassis, such as the 6H122-16, can be used to manage the entire
chassis, and any other attached module through Local Management,
SNMP, or Telnet applications.
1.3.4 Switching Options
The 6H122-16 provides 802.1D switching, 802.1Q switching, or
SecureFast Switching Virtual Network Services between all of the front
panel interfaces.
SecureFast switching and 802.1Q switching allow for future migration to
Virtual Network technologies without requiring the replacement of
existing equipment.
1.3.5 Full Duplex Switched Ethernet
Ports 1 through 14 support Full Duplex Switched Ethernet (FDSE)
operation if the port is operating in Standard Ethernet mode (10 Mbps).
This provides up to 20 Mbps of bandwidth. Ports 15 and 16 also support
Full Duplex operation in Fast Ethernet mode (100 Mbps). This provides
up to 200 Mbps of bandwidth.
1.3.6 Remote Monitoring
The 6H122-16 supports all Ethernet Remote Monitoring (RMON)
groups, which include Statistics, Alarms, Events and History. These four
groups are enabled on all ports by default.
Cabletron Systems RMON Actions is a vendor-specific extension of
RMON and provides the ability to set an “Action” on any SNMP MIB
variable. The Action can be triggered by any RMON Event and/or Alarm.
An example of an Action would be to turn off a MIB-2 interface if a
broadcast threshold is crossed.