Filter
Top Products
Chapter 3: Installation
3-2 6H122-16 User’s Guide
3.2 INSTALLING THE 6H122-16 INTO THE 6C105
CHASSIS
The 6H122-16 can be installed in any of the 5 slots that are available. To
install a module, proceed as follows:
1. Remove the blank panel covering the slot in which the module will be
installed. All other slots must remain covered to ensure proper airflow
and cooling. (Save the blank plate in the event you need to remove the
module.)
2. Carefully remove the module from the shipping box. (Save the box
and packing materials in the event the module must be reshipped.)
3. Locate the antistatic wrist strap shipped with the 6C105 chassis.
Attach the strap to your wrist and plug the cable from the antistatic
wrist strap into the ESD grounding receptacle at the upper right corner
of the 6C105.
4. Remove the module from the plastic bag. (Save the bag in the event
the module must be reshipped.) Observe all precautions to prevent
damage from Electrostatic Discharge (ESD).
5. Examine the module for damage. If any damage exists, DO NOT
install the module. Immediately contact the Cabletron Systems Global
Call Center.
!
CAUTION
Failure to observe static safety precautions could cause
damage to the 6H122-16. Follow static safety handling rules
and properly wear the antistatic wrist strap provided with the
6C105 chassis.
!
CAUTION
Do not cut the non-conductive bag to remove the module.
Damage could result from sharp objects contacting the board
or components.