Cabletron Systems 6H122-16 Switch User Manual


 
Chapter 5: Local Management
5-26 6H122-16 User’s Guide
To establish community names, proceed as follows:
1. Use the arrow keys to highlight the Community Name field adjacent
to the selected access level.
2. Enter the password in the field (maximum 31 characters).
3. Press ENTER.
4. Repeat steps 1 through 3 to modify the other community names.
5. Use the arrow keys to highlight SAVE at the bottom of the screen and
press ENTER. The message “SAVED OK” displays. The community
names are saved to memory and their access modes implemented.
5.9 SNMP TRAPS SCREEN
Since the 6C105 is an SNMP compliant device, it can send messages to
multiple Network Management Stations to alert users of status changes.
The SNMP Traps screen is shown in Figure 5-12.
To access the SNMP Traps screen from the Chassis Menu screen, use the
arrow keys to highlight the SNMP TRAPS menu item and press ENTER.
The Chassis SNMP Traps screen displays.
NOTE
All passwords assigned in the 6C105 SNMP Community
Names screen allow access to both the 6C105 Local
Management screens, and the Local Management screens of
the interface modules that are installed in the chassis. To
configure the interface module to disallow access to the 6C105
Local Management screens, refer to Section 5.16.