Cabletron Systems 6H122-16 Switch User Manual


 
General Configuration Screen
6H122-16 User’s Guide 5-43
In STAND ALONE mode, the module is isolated from the chassis
configuration screens, and the module may not be accessed from a
module that is in DISTRIBUTED mode. This provides additional security
for any module to which the user may wish to restrict access.
Section 5.15.10 describes how to set the Management Mode.
Com (Toggle)
This field allows the user to enable or disable the COM port. The
selection toggles between ENABLED and DISABLED. The default is
ENABLED. For details about setting up the COM port, refer to
Section 5.15.11.
Application (Toggle)
Displays the application set for the COM port. This field allows you to set
the application that the COM port will support, which includes the
following:
Local Management (LM) via a terminal or modem connection
Uninterruptible Power Supply (UPS)
The UPS setting allows you to use the COM port to monitor an American
Power Conversion Uninterruptible Power Supply (UPS). For the UPS, the
baud rate is automatically set to 2400.
The baud rate setting for LM is automatically sensed.
For details about how to configure the COM port for the various
applications, refer to Section 5.15.11.
Clear NVRAM (Toggle)
This allows the user to reset NVRAM to the factory default settings. All
user-entered parameters, such as IP address and Community Names are
then replaced with 6H122-16 default configuration settings. For details,
refer to Section 5.15.13.
NOTE
When using the IP address of the module to establish a remote
connection (such as a Telnet or SNMP connection), the chassis
LM screens will not be available. To access the chassis LM
screens, the IP address of the chassis must be used to
establish the connection.