Filter
Top Products
Specifying Common Settings
4-56
4
Customizing Settings
NOTE
[Limited Functions Mode] is displayed only if an optional finisher is attached.
1
Press (Additional Functions) ➞ [Common Settings] ➞
[Limited Functions Mode].
2
Select [On] or [Off] ➞ press [OK].
NOTE
The Limited Functions Mode is enabled only after you restart the machine (the
main power switch is turned OFF, and then back ON). For instructions on restarting
(turning the main power switch OFF and then ON) the machine, see "Main Power
and Control Panel Power," on p. 1-15.
Returning the Common Settings to Their Defaults
You can restore all of the Common Settings to their defaults (initial settings).
NOTE
•
If you set Language Switch to 'On', and then return the Common Settings to their default
settings, Language Switch is turned 'Off', but the language shown on the touch panel
display remains unchanged. (See "Changing the Language Shown on the Touch Panel
Display," on p. 4-50.)
•
If you set Limited Functions Mode to 'On', and then return the Common Settings to their
default settings, the setting for the Limited Functions Mode remains unchanged.
•
Image forms registered for Register Form for Form Composition are not erased.
1
Press (Additional Functions) ➞ [Common Settings] ➞
[Initialize Common Settings].
2
Press [Yes].