Filter
Top Products
MEAP Settings
6-32
6
System Manager Settings
● If you select [On]:
❑
Select [On] or [Off] for <Use SSL> ➞ press [OK].
Use SSL (Secure Sockets Layer)
● If you select [Off]:
❑
Press [OK].
NOTE
•
Before setting <Use SSL> to 'On', it is necessary to set a default key in Network
Settings (from the Additional Functions screen). (See Chapter 3, "Using a TCP/IP
Network," in the Network Guide.)
•
The Use HTTP mode is enabled only after you restart the machine (the main power
switch is turned OFF, and then back ON). For instruction on restarting (turning the
main power switch OFF and then ON) the machine, see "Main Power and Control
Panel Power, " on p. 1-15.
•
Any changes made to <Use SSL> are also applied to <Use SSL> in Remote UI in
System Settings (from the Additional Functions screen).
Printing Installed Application Information
You can print the MEAP application information, as well as certain system
application information.
NOTE
The information is printed as a report.
1
Press (Additional Functions) ➞ [System Settings] ➞ [MEAP
Settings] ➞ [Print System Information].
[On]: SSL is used to communicate.
[Off]: SSL is not used to communicate.