Filter
Top Products
Print Server Management and Configuration
48 AXIS 1650 User’s Manual
Setting Restrictions
To change print server permissions and restrictions, select Admin |
General Settings => Change and select the Restrictions tab in the Web
interface.
TCP Restriction Enabled When set to Yes, users specified in the IP Address List are rejected or
accepted (depending on how the TCP Restriction Mode is set), to send
print jobs over the print server.
Default = No
TCP Restriction Mode When set to Accept, users specified in the TCP Restriction IP Address List
are allowed to use this print server.
When set to Reject, users specified in the TCP Restriction IP Address List
are not allowed to use this print server.
Default = Accept
TCP Restriction IP Address
List
Here you specify the users which are allowed (or not allowed, depending
on how TCP Restriction Mode is set) to use the print server. IP addresses
or ranges of IP addresses can be specified:
Example IP addresses: 10.13.16.150, 10.13.16.151
Example IP address range: 10.13.16.160-0.13.16.170
Default = <blank>
Note: If your print server is connected to a CAPT 1.0 printer you will
receive an error message stating Network Error if you are not allowed to
print with this print server
SNMP Restriction Enabled When set to Yes, users specified in the SNMP Restriction IP Address List
are rejected or accepted (depending on how the SNMP Restriction mode is
set).
Default = No
SNMP Restriction Mode When set to Accept, only users specified in the SNMP Restriction IP
Address List are permitted to specify/browse the settings for the device
using the SNMP protocol.
When set to Reject, only users specified in the SNMP Restriction IP
Address List are rejected from specifying/browsing the settings for the
device using the SNMP protocol.
Default = Accept
SNMP Restriction IP
Address List
Users specified here are rejected or accepted. IP addresses or ranges of IP
addresses can be specified as follows:
Example IP addresses: 10.13.16.150, 10.13.16.151
Example IP address range: 10.13.16.160-10.13.16.170
Default = <blank>
SLP Restriction Enabled When set to Yes, users specified in SLP Restriction IP Address List are
rejected or accepted (depending on how the SLP Restriction Mode is set).
Default = No
SLP Restriction Mode When set to Accept, only users specified in the SLP Restriction IP Address
List are permitted to specify/browse the settings for the device using the
SLP protocol.
When set to Reject, only users specified in the SLP Restriction IP Address
List are rejected from specifying/browsing the settings for the device