Canon AXIS 1650 Network Card User Manual


 
Print Server Management and Configuration
50 AXIS 1650 User’s Manual
anticipates that there is a router available that automatically senses and
redirects the print server's packets to destinations outside the local
network segment.
Default value: 0.0.0.0
DHCP Enabled Set to Yes to enable DHCP (Dynamic Host Configuration Protocol). DHCP
automatically downloads the IP address to each print server at startup.
Depending on how your network has been configured, other Internet
related parameters (such as the default router, subnet mask, etc.) might
also be set automatically. It is recommended that you verify the settings
when the server has been restarted and then enter any missing parameters
manually.
Default value = No (disabled)
BOOTP Enabled Set to Yes to enable BOOTP (BOOTstrap Protocol). BOOTP downloads the
IP address to each print server at startup. Depending on how your
network has been configured, other Internet related parameters (such as
the default router, subnet mask, etc.) might also be set automatically.
However, we recommend that you verify the settings when the server has
been restarted and then enter any missing parameters manually.
Default value = No (disabled)
RARP Enabled Set to Yes to enable RARP (Reverse Address Resolution Protocol). RARP
downloads the IP address to each print server at startup. This method only
operates over single network segments. Other Internet related parameters
(such as the default router, subnet mask, etc.) must be entered manually
as RARP only sets the IP address.
Default value = No (disabled)
DNS Server Address Specify the IP address of the DNS (Domain Name Server). DNS uses
NetBIOS names to allow clients to locate resources on TCP/IP networks.
Default = 0.0.0.0
DNS Dynamic Update Select Yes to enable DNS (Domain Name Server). DNS uses NetBIOS
names to allow clients to locate resources on TCP/IP networks.
Default value = No
DNS Host name Specify DNS Host name. This name will be used in all environments as
the identifier of this print server.
Default value = <blank>
DNS Domain Name Specify the name of the domain to which the print server belongs.
Domain refers to a set of computers on a network that have been assigned
a common name. A domain might contain several workgroups.
Default = <blank>
WINS Enabled Select Yes to enable WINS (Windows Internet Name Service) over TCP/IP.
WINS uses NetBIOS names to allow Windows based clients to locate
resources on TCP/IP networks.
Default value = Yes
WINS Server Address Specify the IP address of the primary WINS server. The WINS server is
used for identifying a computers by its host name instead of by its IP
address.
Default value = 0.0.0.0
WINS Host Name Specify the WINS host name, which will be used as the identifier of your