Filter
Top Products
6-9
6
SENDING DOCUMENTS
Redialling when the line is busy
There are two methods of redialling: manual redialling and automatic redialling. This section explains these
two methods.
Manual redialling____________________________
Press [Redial/Pause] to dial the last number you dialled with the numeric buttons. (This starts redialling
regardless of whether automatic redialling is enabled.)
KK
Cancelling manual redialling
To cancel manual redialling, press [Stop].
Automatic redialling _________________________
KK
What is automatic redialling?
When you are sending a document using memory sending and the receiving party’s line is busy, the fax
waits the specified time and then dials the same number again. You can set the fax to redial several times if
previous attempts fail because of a busy signal. This feature is called automatic redialling.
After the initial dial attempt, the fax will try to dial again. Automatic redialling can be turned off and on.
The number of redialling attempts and the time interval between attempts can also be adjusted. (see AUTO
REDIAL, p. 8-4)
If all redialling attempts are unsuccessful, the fax will cancel the transmission and print an ERROR TX
REPORT to remind you that the transmission was not completed. (see p. 8-11)
When automatic redialling is in use, the LCD alternately displays AUTO REDIAL and the transaction
number (TX/RX NO. xxxx) while the fax is waiting to redial.