Filter
Top Products
CANON Digital Galvano Scanner System GM-1000 Series
Users Manual 1.20
135
Usually, settings in the window do not need to be changed, however, need to change when
the connected COM port differs. When writing fails frequently, change the baud rate (default
value of 57600) to a smaller value and try again.
6. When Write Complete displays in the log display area, it is finished.
7. Shut down GCFlash. (It is necessary to completely shut down once.)
8. Turn off the GC-201 controller’s power.
9. Updating the DSP of Axis 2
With the GC-201 controller’s power turned off, set the jumper switches and DIP switches as
follows.
SW2 : 1-ON
JP1 : 2-3 Short
JP2 : 2-3 Short
10. Follow instructions 3 to 6.
11. Shut down GCFlash and turn off the GC-201 controller’s power.
12. With the GC-201 controller’s power turned off, return settings to the jumper switches and DIP
switches as follows.
JP1
1 2 3
JP2
1 2 3
SW2
1
2
OFF
ON
According to the controller settings, the default state of "2" of SW2 will differ. This is
regardless of a firmware update. Do not change from the default state.