Filter
Top Products
Index
IN-46
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter Software Configuration Guide
OL-12189-01
stratum, NTP 6-2
stub areas, OSPF 38-36
stub routing
EIGRP 38-29
PIM 38-27
subdomains, private VLAN 15-1
subnet mask 38-8
subnet zero 38-8
success response, VMPS 12-29
summer time 6-13
SunNet Manager 1-5
supernet 38-9
SVIs
and IP unicast routing 38-6
and router ACLs 34-4
connecting VLANs 10-6
defined 10-5
routing between VLANs 12-2
switch console port 1-6
Switch Database Management
See SDM
switched packets, ACLs on 34-36
Switched Port Analyzer
See SPAN
switched ports 10-2
switchport block multicast command 25-7
switchport block unicast command 25-7
switchport command 10-15
switchport mode dot1q-tunnel command 16-6
switchport protected command 25-6
switch priority
MSTP 18-22
STP 17-21
switch software features 1-1
switch virtual interface
See SVI
synchronization, BGP 38-53
syslog
See system message logging
system clock
configuring
daylight saving time 6-13
manually 6-11
summer time 6-13
time zones 6-12
displaying the time and date 6-12
overview 6-1
See also NTP
system message logging
default configuration 31-4
defining error message severity levels 31-9
disabling 31-4
displaying the configuration 31-14
enabling 31-5
facility keywords, described 31-14
level keywords, described 31-10
limiting messages 31-10
message format 31-2
overview 31-1
sequence numbers, enabling and disabling 31-8
setting the display destination device 31-5
stack changes, effects of 31-2
synchronizing log messages 31-6
syslog facility 1-13
time stamps, enabling and disabling 31-8
UNIX syslog servers
configuring the daemon 31-12
configuring the logging facility 31-13
facilities supported 31-14
system MTU and IEEE 802.1Q tunneling 16-5
system name
default configuration 6-15
default setting 6-15
manual configuration 6-15
See also DNS
system prompt, default setting 6-14, 6-15
system resources, optimizing 8-1