Filter
Top Products
38-97
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter Software Configuration Guide
OL-12189-01
Chapter 38 Configuring IP Unicast Routing
Configuring Protocol-Independent Features
Use the no route-map map-tag global configuration command or the no match or no set route-map
configuration commands to delete an entry. Use the no ip policy route-map map-tag interface
configuration command to disable PBR on an interface. Use the no ip route-cache policy interface
configuration command to disable fast-switching PBR. Use the no ip local policy route-map map-tag
global configuration command to disable policy-based routing on packets originating on the switch.
Filtering Routing Information
You can filter routing protocol information by performing the tasks described in this section.
Note When routes are redistributed between OSPF processes, no OSPF metrics are preserved on the Catalyst
Switch Module 3110.
Setting Passive Interfaces
To prevent other routers on a local network from dynamically learning about routes, you can use the
passive-interface router configuration command. Then routing update messages are not being sent
through a router interface. When you use this command in the OSPF protocol on a Catalyst Switch
Module 3110, the interface address that you specify as passive appears as a stub network in the OSPF
domain. OSPF routing information is neither sent nor received through that interface.
In networks with many interfaces, you do not need to manually set them as passive. You can set all
interfaces to be passive by default by using the passive-interface default router configuration command.
You can then manually setting interfaces where adjacencies are desired.
Beginning in privileged EXEC mode, follow these steps to configure passive interfaces:
Step 11
end Return to privileged EXEC mode.
Step 12
show route-map [map-name] (Optional) Display all configured route maps or only the one
specified to verify configuration.
Step 13
show ip policy (Optional) Display policy route maps attached to interfaces.
Step 14
show ip local policy (Optional) Display whether or not local policy routing is
enabled and, if so, the route map being used.
Step 15
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
router {bgp | rip | ospf | eigrp} Enter router configuration mode.
A switch running the IP base feature set (for example, the Catalyst
Switch Module 3012) supports only the rip keyword.
Step 3
passive-interface interface-id Suppress sending of routing updates through the specified Layer 3
interface.
Step 4
passive-interface default (Optional) Set all interfaces as passive by default.